Last
Revision:
4 Extreme Health 3 3 High Fire 0 2 Moderate Reactivity 1 1 Slight Other 0 - Least
Emergency CHEMTREC 800-424-9300
HMIS Hazard
Phones:
SECTION 1 - MATERIAL IDENTIFICATION
NAME: EGG CLEAN BOOSTER
SECTION 2 -
HAZARDOUS INGREDIENTS
Sodium Hydroxide 1310-73-2 25% 2 mg/m3 NO
Water 007732-18-5 75% NO
SECTION 3 CHEMICAL AND PHYSICAL PROPERTIES
Appearance: Clear or opaque colorless liquid Boiling Point (oF): about 293 oF
Odor: Odorless Freezing Point (oF): ~0 oF
pH: ~14 Specific Gravity (H2O=1): 1.274
Water solubility: Complete Vapor Pressure, mm Hg, 20oC: ND
Vapor Density (air=1): ND Volatile Organic (VOC) content: NA
Evaporation Rate (Butyl Acetate = 1) ND
SECTION 4 FIRE AND EXPLOSION HAZARDS
Flash Point (Method): None Explosive Limits: Lower None Upper None
Flammable Limits: None Auto Ignition Temperature: None
Extinguishing Media: Does not burn.
Special Fire Fighting Procedures and Hazards: Self contained positive pressure breathing apparatus.
Unusual Fire & Explosion Hazards: Can react violently on contact with water producing heat and gas.
SECTION 5 REACTIVITY INFORMATION
Stable: X Unstable: Hazardous Polymerization: Occurs: Does not Occur: X
Conditions to Avoid: Avoid contact with acids without good agitation. Exercise care if mixing with water as heat is generated with spattering and boiling.
Materials to Avoid: Acids will cause violent reaction with heat and gas. Contact with aluminum, brass, tin, zinc creates flammable hydrogen gas. Reaction with reducing sugars creates carbon monoxide.
Decomposition Products: Does not decompose.
Egg Clean Booster Page
2
SECTION 6 HEALTH HAZARDS PROTECTIVE MEASURES FIRST AID
Carcinogen: No
EYES: Extremely corrosive to the eyes with possible permanent damage. Use chemical goggles when handling this material. In the event of contact immediately flush with water for 15 minutes. Get immediate medical attention if symptoms develop.
SKIN: Extremely corrosive and destructive causing severe burns with deep ulcerations on prolonged contact. Use rubber or neoprene gloves and apron when handling this material. In the vent of contact immediately wash with water for 15 minutes. Get prompt medical attention if symptoms develop.
INHALATION: Mist or vapors can cause severe irritation or damage to the respiratory system.
INGESTION: Corrosive to the mouth, esophagus and mucous membranes causing severe burns with vomiting, diarrhea and death. Fatal dose is about 5 grams. Drink large amounts of water or milk. DO NOT induce vomiting. Get immediate medical attention.
IN ALL CASES: GET PROMPT MEDICAL ATTENTION IF ADVERSE EFFECTS PERSIST
PRIMARY ROUTES OF ENTRY: Skin, eyes, inhalation, ingestion
HYGIENE: Wash
hands and face before eating or drinking.
SECTION 7 PRECAUTIONS FOR SAFE HANDLING, STORAGE AND USE
SPILLS AND LEAKS: Contain to prevent loss to the environment. Clear area of non-emergency personnel. Collect excess material. Neutralize the residual material and flush to a sanitary sewer.
STORAGE AND HANDLING: Keep containers tightly closed. Store at ambient temperatures.
WASTE DISPOSAL: Follow recommendations of local, state and federal regulations.
EMPTY CONTAINERS: Rinse thoroughly with water. Send to a recycling center or return to Wausau Chemical Corporation.
SECTION 8 REGULATORY INFORMATION
DOT SHIPPING DESCRIPTION: Corrosive liquid, basic, inorganic, N.O.S., (Sodium Hydroxide), 8, UN3266 PG II
LABEL REQUIRED: Corrosive
The
information contained herein is given in good faith, but no warranty,
representation, inducement or license of any kind is made, except that the
information is accurate to the best of Wausau Chemical Corporations
knowledge, or is obtained from sources believed by Wausau Chemical
Corporation to be reliable and accurate. Wausau Chemical Corporation does
not assume any legal responsibility for use or reliance upon the
information being furnished. Customers are encouraged to conduct their own
tests. Before using any product, read the container label directions as
well as the Material Safety Data Sheet.
ND Not Determined NA Not Applicable NE Not Established