Last
Revision:
4 Extreme Health 2 3 High Fire 0 2 Moderate Reactivity 0 1 Slight Other 0 - Least
Emergency CHEMTREC 800-424-9300
HMIS Hazard
Phones:
SECTION 1 - MATERIAL IDENTIFICATION
NAME: SOLU SOFT
SYNONYMS:
SECTION 2 -
HAZARDOUS INGREDIENTS
1-Octadecanaminium,N,N-Dimethyl-N-Octadecyl Chloride
107-64-2 NE NO
Boric Acid 10043-35-3 5 mg/m3 NO
SECTION 3 CHEMICAL AND PHYSICAL PROPERTIES
Appearance: White granular powder Boiling Point (oF): NA
Odor: None Melting Point (oF): ND
pH: about 9.0 for 1% solution Specific Gravity (H2O=1 @ 70oF): NA
Water solubility: Complete Vapor Pressure, mm Hg, 20oC: NA
Vapor Density (air=1): NA Volatile Organic (VOC) content: NA
Evaporation Rate (Butyl Acetate = 1) NA
SECTION 4 FIRE AND EXPLOSION HAZARDS
Flash Point (Method): None Explosive Limits: Lower None Upper None
Flammable Limits: None Auto Ignition Temperature: None
Extinguishing Media: Dry chemical, water fog, regular foam.
Special Fire Fighting Procedures and Hazards: None
Unusual Fire & Explosion Hazards: Concentrations of dust can be explosive.
SECTION 5 REACTIVITY INFORMATION
Stable: X Unstable: Hazardous Polymerization: Occurs: Does not Occur: X
Conditions to Avoid: None known.
Materials to Avoid: Strong mineral acids, strong alkalis or oxidizing agents.
Decomposition Products: Not Known.
Solu Soft Page
2
SECTION 6 HEALTH HAZARDS PROTECTIVE MEASURES FIRST AID
Carcinogen: No
EYES: Severe eye irritant. Use chemical goggles when handling this product. In the event of contact flush with water for 15 minutes. Get medical attention if symptoms develop.
SKIN: Can cause skin irritation on repeated or prolonged contact. Use neoprene or rubber gloves and apron when handling this product. In the event of contact wash with water for 15 minutes. Get medical attention if symptoms develop.
INHALATION: Mist or vapors can cause irritation of the respiratory system.
INGESTION: Corrosive to the mouth, esophagus and mucous membranes. Drink large amounts of water. Do Not induce vomiting. Get immediate medical attention.
IN ALL CASES: GET PROMPT MEDICAL ATTENTION IF ADVERSE EFFECTS PERSIST
PRIMARY ROUTES OF ENTRY: Skin, eyes, inhalation, ingestion.
HYGIENE: Wash
hands and face before eating or drinking.
SECTION 7 PRECAUTIONS FOR SAFE HANDLING, STORAGE AND USE
SPILLS AND LEAKS: Contain to prevent loss to the environment. Collect excess material. Flush
the residual material to a sanitary sewer.
STORAGE AND HANDLING: Keep containers tightly closed and away from moisture. The material is hygroscopic and will get hard if exposed to moisture. Store at ambient temperatures.
WASTE DISPOSAL: Follow recommendations of local, state and federal regulations.
EMPTY CONTAINERS: Send to a recycling center or return to Wausau Chemical Corporation.
SECTION 8 REGULATORY INFORMATION
DOT SHIPPING DESCRIPTION: None
LABEL REQUIRED None
The
information contained herein is given in good faith, but no warranty,
representation, inducement or license of any kind is made, except that the
information is accurate to the best of Wausau Chemical Corporations knowledge,
or is obtained from sources believed by Wausau Chemical Corporation to be
reliable and accurate. Wausau Chemical Corporation does not assume any
legal responsibility for use or reliance upon the information being
furnished. Customers are encouraged to conduct their own tests. Before
using any product, read the container label directions as well as the
Material Safety Data Sheet.
ND Not Determined NA Not Applicable NE Not Established